Free Tech Tips – weight distribution

>> Tech Tip - Chassis , Tech Tips >> Free Tech Tips – weight distribution

Due to the fact that most R/C cars have their motor placed closer to the backend of the chassis, the rear and front ride heights tend to be uneven (the heavier side goes lower). An artificially configured “lower front” can benefit steering but is easier to go “diving” (which can make the car slides) when the brake is hit hard.

Total Views: 835 ,

Related Post

TT01E spur gear damage due to the use of improper screws

On a TT01E, there are two screws which attach the upper deck to the gearbox…

Small fiber glass RC boat (especially a full body hydro) and brushless system

This is a full body hydroplane. The problem with a BL setup for a small…

Replacing a bad spur gear when the shaft cup cannot be removed…

Lets say you are about to remove the center shaft cup so to take out…