Simple upgrade of the front suspension
This is a simple upgrade of the front suspension for the Tamiya Hornet and Grasshopper. Marginally better than before.
Tamiya DT02 gear ratio
By default the DT02 has a 55T spur. The motor pinion is either 17T or 19T, 0.8 mod.
Durability of 3d print spur gear
This photo shows a 3d printed spur gear (PLA) that has been used for at least 15 rounds of 10…
Significant weakness of the Manta Ray drive train
As can be seen from this photo, when the gear box cover cracks (which can happen quite easily), loose gears…
Flying High: A Beginner’s Guide to RC Helicopters and RC Planes
Welcome to the exhilarating world of radio-controlled (RC) aviation! Whether you’re an aspiring pilot or a hobbyist looking to take…
Front steering issue with the Tamiya WT01
This is a known issue with the Tamiya WT01 – when you oversteer the dog bone shaft will get stuck…
Techtip: Vintage Tamiya Frog front steering issues
With the hex adapter for the Frog, there is significant room for play. Very careful shimming must be done to…
The Voltage Question: Is It OK to Run 3S Lipo on a Stock Brushed Motor?
If you hang around the RC hobby long enough, you’ll eventually hear the old wives’ tale: “If you run 3S on…
Techtip: Tamiya Avante / Egress original versions wheel adapters
The Tamiya original Avante/Egress wheel adapters do not use pin to secure the hex. There is a E clip to…