This photo shows a 3d printed spur gear (PLA) that has been used for at least 15 rounds of 10 minutes run under a high-torque 550 motor. It seems like the gear is still in good shape.
Total Views: 423 ,
Categories:
Related Post
ESC that supports both brushed and brushless operation
This TBLE 02S Tamiya ESC supports both. For brushed operation simply ignores the orange wire.…
Why a bathtub chassis is bad…
See this. The bathtub becomes a trash bin.
Lipo VS Nimh
The photo shows a small 2000mah 20C 2s lipo VS a 7.2V 5000mah Nimh pack.…