Refer to the example below, the lower arm’s join was broken after a crash.
Instead of getting a replacement, you may drill a hole and then insert a screw over there to serve as a join:
Total Views: 665 ,
Categories:
Related Post
Hex Screws on RC Cars: Love ’Em or Leave ’Em?
If you’ve been in RC for more than a minute, you’ve probably had a run-in…
Calculating gearbox/transmission ratio for belt drive 4WD
On a typical belt driven 4WD with its motor interacting with the center gear, this…
Installing a diff on a shaft driven 4wd
When you fit a diff into the gearbox, keep in mind the side does matter…