RC Tech Tip Video: TT02 loose joint at the front

>> RC Videos , Tech Tip - Steering >> RC Tech Tip Video: TT02 loose joint at the front

If your TT02 fails to run a straight line randomly, chance is that the plastic ball joints at the front are getting loose upon excessive wear (see the photos below).

 

You can wrap a thin layer of duct tape or water seal tape around it. Don’t worry – it will not affect steering too much.

Total Views: 969 ,

Related Post

3D printed front steering block

When you 3D print parts for the front steering block, there are a lot of…

Front steering issue with the Tamiya WT01

This is a known issue with the Tamiya WT01 - when you oversteer the dog…

Tamiya M04M knuckle arm to be used on WT-01

The knuckle arm is also known as the "steering knuckle" or "hub carrier." This part…