One way to crash the TC01 front diff
The front body post is secured via one screw installed upside down. If this is…
0 Comments
IDR vs FDR
Gear ratio is a fundamental concept in RC car performance, balancing acceleration, speed, and torque.…
0 Comments
0.6 Mod vs. 32/48 Pitch
0.6 Mod is close in size to 48 pitch (imperial measurement) but not identical. They…
0 Comments
Kyosho Fazer Mk2 Vs Tamiya TT02
Out of the box the Fazer mk2 has a 32t pinion 48dp, so if the…
0 Comments
Tamiya spur gear pin issue
The pin that holds the spur in place may fall off, so a little bit…
0 Comments
Front one way reversed
The front one way on this car is installed in reverse. Therefore when it runs…
0 Comments
RWD on frosty track surface
https://youtu.be/Zcq62FKPPFo Rear-wheel drive (RWD) vehicles tend to have poorer traction on frosty or slippery roads…
0 Comments
TT01 motor mounting position and recommended Pinion/Spur
TT01 has a very tight compartment for motor and gear. If you are using non-Tamiya…
0 Comments
Why high quality ball bearings are way more expensive than the cheap ones
High quality ball bearings are manufactured based on selective assembly. Selective assembly increases the cost…
0 Comments