{"id":7665,"date":"2026-01-18T12:27:27","date_gmt":"2026-01-18T12:27:27","guid":{"rendered":"https:\/\/rcpress.com\/wp\/?p=7665"},"modified":"2026-01-29T15:38:06","modified_gmt":"2026-01-29T15:38:06","slug":"converting-a-1-16-marui-shogun-to-real-rc","status":"publish","type":"post","link":"https:\/\/rcpress.com\/wp\/?p=7665","title":{"rendered":"Converting a 1\/16 Marui Shogun to real RC"},"content":{"rendered":"

\"\"<\/a><\/p>\n

The photos below show the steps taken:\"\"<\/a><\/p>\n

First we expose and remove the existing circuit board and servo.<\/p>\n

\"\"<\/a><\/p>\n

Make sure the two motor wires remain accessible.<\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

Then we install a standard real RC servo.<\/p>\n

\"\"<\/a><\/p>\n

Then we connect, test and secure a receiver and an ESC.<\/p>\n

\"\"<\/a> \"\"<\/a><\/p>\n

Finally we arrange a small opening on the side so the 2.4G antenna and the ESC switch can reach the outside.<\/p>\n

\"\"<\/a><\/p>\n

Done.<\/p>\n

\"\"<\/a><\/p>\n